SK-AM62P-LP: How enable raspberry PI panel on am62p evk

Hello,

Please point me to the other thread where you saw this panel discussed.

We can support questions about TI hardware and TI software on these forums. However, we cannot answer questions about non-TI parts using non-TI software. In general, "How do I get a Raspberry PI peripheral connected to a Linux processor" is outside the scope of what we can support.

An example of a question we could help with is something like this: Let's say you learn how to connect the Raspberry PI display to a Linux processor. You are following the steps, but it seems like the low-level TI driver that is between the display driver and the hardware is not behaving the way you expect. We could then help you debug that lower-level TI driver.

Regards,

Nick

Hi,

Here is the thread that TI recommends using the panel for testing with SK-62P-LP evk

https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1372152/sk-am62p-lp-tested-lvds-and-mipi-dsi-display-part-number

I though TI may have some documented steps how to enable the panel.

I shall give it a try. 

Thanks.

Hello,

Thanks for sending that link. I will ask Krunal to comment. Feel free to ping the thread if you do not get a response by the beginning of next week.

Regards,

Nick

You can simply add the following line to your uEnv.txt to enable the display panel overlay:

name_overlays=ti/k3-am62p5-sk-dsi-rpi-7inch-panel.dtbo