TDA2xx: SD-Card booting: Jumping to MPU CPU0 Application (BIOS)

JAGADISH GOLLA

Hello,

I had created two Algplugin and integrated them in my Usecase .

I tried to boot from an SD card. The TDA2xx only works until "Jumping to MPU CPU0 Application..." appears in the Terminal.

over 6 years ago

0 Yordan Kamenov over 6 years ago

TI__Mastermind 42515 points

Hi Jagadish,

can you check those threads with the same issue and see if they can give you any directions:
e2e.ti.com/.../576746
e2e.ti.com/.../774364

Regards,
Yordan

0 JAGADISH GOLLA over 6 years ago in reply to Yordan Kamenov

Prodigy 30 points

Hi Yordan ,

I had already gone through the threads and tried them, But it was not helpful. Can you give me another solution ?

0 Anuj Gupta over 6 years ago in reply to JAGADISH GOLLA

TI__Genius 15985 points

Hi,

Can you put a break point inside the init function of your alg_plugin and check what is going wrong?
I hope the alg_id you have created , its value is less than the max alg_id for that core.

Regards,
Anuj

0 JAGADISH GOLLA over 6 years ago in reply to Anuj Gupta

Prodigy 30 points

Hi Anuj,

Thanks for ur reply , its working. The alg_id i have created is greater than the max value, i rectified it and its working...

Processors

Processors forum

TDA2xx: SD-Card booting: Jumping to MPU CPU0 Application (BIOS)