TDA4VMXEVM: Issues to load the new network model.

Binduhasini Sairamesh

Part Number: TDA4VMXEVM

Hello,

I am new to TI platform.

I followed the SDK user guide to load the binary on to the TDA4 board. I was able to run the default configuration.

I came to know from the user guide that the binary would try to run the infer files from the config.list. When I try to change the config.list by pointing to a newly imported model, it is again executing the old config.list.

I tried reloading and terminating the execution and trying to run again. It is still executing the old config list.

Any thoughts on this issue is greatly appreciated.

Thanks a lot for all your kind suggestion in advance,

Bindu

over 5 years ago

0 Binduhasini Sairamesh over 5 years ago

Intellectual 940 points

Hello,

Thanks to Jelena from TI who helped me figure out the issue.

I had to modify the config lists in the PC as this is the only file which is being read from the PC during run time.

That fixed my issue.

Thanks,

Bindu

0 Rishabh Garg over 5 years ago in reply to Binduhasini Sairamesh

TI__Guru 55685 points

Hi Bindu,

Yes you need to modify config list in PC.

Thanks for the updating the thread.

Regards,

Rishabh

Processors

Processors forum

TDA4VMXEVM: Issues to load the new network model.