TDA4VM: What's the Fusion1 board/platform and where to buy?

Keelung Yang

Expert 1796 points

Part Number: TDA4VM

Hi,

I notice that there are some boards / platforms about Fusion / Fusion1 in Vision Apps document and e2e forums:

software-dl.ti.com/.../group_apps_basic_demos_app_multi_cam.html

software-dl.ti.com/.../group_apps_srv_demos_app_srv_calibration.html

And most of users use "Fusion Board/EVM" in e2e forum.

So,

What's the difference between Fusion and Fusion1?
What's the difference between Fusion1 board and Fusion1 platform?
Where is the official info of Fusion/Fusion1 board/platform?
It's made by Ti or 3rd party?
Should Ti document it's orderiong info as sensors in imaging release notes?

over 5 years ago

0 Robert Eschler over 5 years ago

TI__Guru 57025 points

The Fusion board is a add-on board for the Jacinto6 and Jacinto7 EVMs. There is no difference between Fusion and Fusion1, and no difference between board and platform. Specific Information and ordering info is available from its manufacturer (SVTronics). Link provided below:

https://svtronics.com/TI_Jacinto/EVM577PFUSION-V1-0-fusion

0 Keelung Yang over 5 years ago in reply to Robert Eschler

Expert 1796 points

Then why use different words / terms in official documents?

+1 Robert Eschler over 5 years ago in reply to Keelung Yang

TI__Guru 57025 points

Originally there was just the 'Fusion' design. There is now a follow-on design with FPD-Link IV devices, the design is referred to as 'Fusion2'. So with the introduction of 'Fusion2', the original 'Fusion' design also started to get referred to as 'Fusion1'.

Processors

Processors forum

TDA4VM: What's the Fusion1 board/platform and where to buy?