TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197740 Discussions
  • Not Answered

    C code generation problem while building the simulink model 0 Locked

    548 views
    2 replies
    Latest over 12 years ago
    by kazunobu tanno
  • Discussion

    Found jerky image issue on DM365 Locked

    2765 views
    14 replies
    Latest over 12 years ago
    by Kedar Chitnis
  • Not Answered

    VPFE Interrupts 0 Locked

    911 views
    5 replies
    Latest over 12 years ago
    by Eric Sun41402
  • Answered

    how to install omapconf 0 Locked

    1673 views
    5 replies
    Latest over 12 years ago
    by Nicolas Dechesne
  • Answered

    About AM1808 pin statement during POR 0 Locked

    214 views
    2 replies
    Latest over 12 years ago
    by g.f.
  • Not Answered

    ubuntu kernel not coming up on beagle board xm rev c 0 Locked

    607 views
    6 replies
    Latest over 12 years ago
    by taher kawantwala
  • Answered

    Can't access CNTFRQ register 0 Locked

    1902 views
    8 replies
    Latest over 12 years ago
    by Sujith KV
  • Not Answered

    Learningmedia 0 Locked

    128 views
    0 replies
    Started over 12 years ago
    by superman_1987x
  • Not Answered

    ICE Board SPI FLASH. 0 Locked

    1929 views
    4 replies
    Latest over 12 years ago
    by BrandonAzbell
  • Not Answered

    "Is is it possible to use DM365 Processor on DM368 Leopardboard". 0 Locked

    120 views
    1 reply
    Latest over 12 years ago
    by Radhesh Bhat
  • Answered

    Need a dynamically changing time based interrupt on MSP430, use Clock or TImer in SYS/BOIS? 0 Locked

    441 views
    1 reply
    Latest over 12 years ago
    by ScottG
  • Answered

    OMAP4ISS for Android ICS 0 Locked

    313 views
    2 replies
    Latest over 12 years ago
    by Abhijit Naik2
  • Not Answered

    yuv data from a8 to vpss 0 Locked

    362 views
    1 reply
    Latest over 12 years ago
    by Badri Narayanan
  • Not Answered

    A question about H264 codec in DVRRDK 0 Locked

    179 views
    1 reply
    Latest over 12 years ago
    by Badri Narayanan
  • Not Answered

    ipcInM3Link_tsk.c: pFrame != NULL : failed !!! 0 Locked

    160 views
    1 reply
    Latest over 12 years ago
    by Badri Narayanan
  • Not Answered

    SCD input frame verification 0 Locked

    227 views
    1 reply
    Latest over 12 years ago
    by Badri Narayanan
  • Not Answered

    Kernel gets hang without RTC battery 0 Locked

    478 views
    3 replies
    Latest over 12 years ago
    by Renjith Thomas
  • Not Answered

    beaglebone bad arp response checksum 0 Locked

    590 views
    0 replies
    Started over 12 years ago
    by Jon Peterson
  • Answered

    Development kits available and IDE for OMAPL138B C6 integra DSP+ARM processor ..... 0 Locked

    142 views
    2 replies
    Latest over 12 years ago
    by Harisha K S
  • Not Answered

    where do I get MAC addresses for the 1808? 0 Locked

    252 views
    2 replies
    Latest over 12 years ago
    by Chris Gray
<>