TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] SK-AM64B: What is the purpose of --operation=flash-phy-tuning-data ?

    Vaibhav Kumar
    Vaibhav Kumar
    Part Number: SK-AM64B Tool/software: Greetings All, In MCU PLUS SDK offering, across Sitara SoCs, one must have come across different configuration files. These configuration files are located inside the directory: MCU_PLUS_SDK_INSTALL_PATH\tools…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM69A: BOOTING FROM EMMC WITHOUT SD CARD

    Gokul Praveen
    Gokul Praveen
    Part Number: AM69A Other Parts Discussed in Thread: AM69 Tool/software: How to boot from eMMC without SD card?
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: Undeclared Identifier for MCU GPIO Interrupt Routers

    Tushar Thakur
    Tushar Thakur
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: SYSCONFIG Tool/software: I am trying to upgrade my project to use the new MCU+ SDK 10.1 and I'm running into a compilation error saying that the interrupt router number is undeclared. This…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62Ax / AM62Px / AM62D-Q1 / AM62L / AM64x / AM243x (ALV) / AM335x Design Recommendations / Custom board hardware design - Schematics review checklists

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62L Tool/software: Hi Board designers The AM64x, AM62x, AM62Ax, AM62D-Q1, AM62Px and AM62L custom board Schematic review Checklist application note provides a supplemental design check…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7-Q1: Deploy MMYOLO on AM62A, YOLOV8 nano as example.

    Adam Hua
    Adam Hua
    Part Number: AM62A7-Q1 Tool/software: MMYOLO is an open source repo for quick yolo model evaluation. Deployment MMYOLO on TI processor like AM6x or TDAx requires some modifications on this repo. This FAQ uses yolov8 as example to demonstrate how to…
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Queries related to SysConfig-PinMux IOSET and Voltage Conflict

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62P Tool/software: Hi TI Experts, I see IOSET option and Voltage Conflict indication while using SysConfig-PinMux. Can you provide additional inputs on the IOSET and Voltage configuration
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM64B: Incorrect auto-generated MAC port 2 PHY configuration

    Nitika Verma
    Nitika Verma
    Part Number: SK-AM64B Other Parts Discussed in Thread: DP83869 , SYSCONFIG Tool/software: The two Ethernet Ports on SK-AM64x are connected to two separate Gigabit Ethernet PHY Transceivers DP83867. On enabling MAC Port 2 in SK-AM64x networking…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Queries related to passive components values, tolerance, voltage rating

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, 1. In the SK/EVM i see 49.9K resistor used. Can i use a standard value instead 2. In the SK/EVM i see a number of resistors used with 1% tolerance for pullups and series resistors. Can i use standard…
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design – Queries related to Residual Voltage, Detection and supply decay

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: TPS65219 , TPS6594-Q1 , AM62P Tool/software: HI TI experts, I have the below queries related to residual voltage 1. What are the causes for Residual Voltage 2. Effect of Residual Voltage on…
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7-Q1: SDIO driver strength change

    Biao Li
    Biao Li
    Part Number: AM62A7-Q1 Other Parts Discussed in Thread: AM62A7 Tool/software: Hi Expert, Customer was doing EMC test, it was found that the EMMC CLOCK exceeded the standard by 10dB at 1.8GHz and 1.6GHz. Can the output strength capability of the…
    • 9 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198401 Discussions
  • Answered

    Power sequence on AM3358 demo board with DDR3 0 Locked

    650 views
    1 reply
    Latest over 13 years ago
    by ddomke
  • Not Answered

    AM3359 (TMDXICE3359) How to remove StarterWare? 0 Locked

    367 views
    1 reply
    Latest over 13 years ago
    by PratheeshGangadhar
  • Not Answered

    Generating executable binary - run and load address mismatch 0 Locked

    228 views
    1 reply
    Latest over 13 years ago
    by PratheeshGangadhar
  • Answered

    MMC1 boot question 0 Locked

    2387 views
    16 replies
    Latest over 13 years ago
    by peaves
  • Answered

    AM335x Decoupling Caps 0 Locked

    376 views
    2 replies
    Latest over 13 years ago
    by peaves
  • Not Answered

    Where is the function 'appMain'? 0 Locked

    202 views
    0 replies
    Started over 13 years ago
    by He
  • Answered

    What is the path to the platform? 0 Locked

    522 views
    1 reply
    Latest over 13 years ago
    by Sasha Slijepcevic
  • Answered

    DM6446 dvsdk building problem 0 Locked

    242 views
    2 replies
    Latest over 13 years ago
    by He
  • Answered

    Does c6678 core local reset invalidate L1 & L2 caches? 0 Locked

    408 views
    2 replies
    Latest over 13 years ago
    by Joel Keller
  • Not Answered

    c5515 on ccs4 cannot install dsplib 0 Locked

    224 views
    0 replies
    Started over 13 years ago
    by jingrui zhang
  • Suggested Answer

    multiple USB endpoints 0 Locked

    574 views
    1 reply
    Latest over 13 years ago
    by MWagner
  • Answered

    Gst-openmax decoder omx_h264dec blocked when finish decode avi file 0 Locked

    1376 views
    5 replies
    Latest over 13 years ago
    by Manuel Contreras
  • Answered

    GPIO questions 0 Locked

    211 views
    1 reply
    Latest over 13 years ago
    by Chad Courtney
  • Answered

    Simple Example for Starters regarding EVM6678L 0 Locked

    691 views
    8 replies
    Latest over 13 years ago
    by Muhammad Faisal1
  • Not Answered

    Packaging information of C665x/C667x 0 Locked

    223 views
    1 reply
    Latest over 13 years ago
    by Chad Courtney
  • Not Answered

    problem when I want to get my EVM6678LE back to factory default state 0 Locked

    187 views
    2 replies
    Latest over 13 years ago
    by ArunMani
  • Not Answered

    SGX530 features broken with QT 0 Locked

    330 views
    0 replies
    Started over 13 years ago
    by Katia Formiglio
  • Not Answered

    McBSP DMA (IRQ?) stops after underruns 0 Locked

    390 views
    1 reply
    Latest over 13 years ago
    by Alexey Smirnov
  • Discussion

    printf problem using TMS320DM8168, please help me,thank you! Locked

    226 views
    1 reply
    Latest over 13 years ago
    by Larissa Swanland
  • Not Answered

    Modifying PLL settings of DM365 in linux 0 Locked

    262 views
    0 replies
    Started over 13 years ago
    by Jan Pohanka
<>