Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Other Parts Discussed in Thread: AM620-Q1 , AM62P , AM625 , SK-AM62P-LP Hi TI Experts,
I have the below queries regarding the OLDI interface
Supported display configurations. Query regarding 8-lane, 4-lane and electrical compatibility.
Is there…
Part Number: TDA4VM I do not have UART boot mode on my custom board due to lack of switch / pins which can configure the boot mode. Is there a way by which I can change the boot mode in software using gel scripts?
Part Number: PROCESSOR-SDK-J721E By default trace and assert functionalities are disabled in the VHWA PDK driver. This article explains how to enable it in the VHWA drivers.
Part Number: SK-AM64B Other Parts Discussed in Thread: TCA9538
Hello TI,
I’m currently working on TI’s SK-AM64B boards, trying to move them from HS-FS to HS-SE mode.
To do so, I’m using the OTP Keywriter tool with MCU+ SDK for AM64x in its latest…
Part Number: AM62X-PET-CALC
Hi TI
When i finish the PINMUX config and power domain config, there is confict message show as below，Can i suppress these two warning ?
As the MCU GPIO is 3v3 level ,so i connect the VDDSHV_MCU to 3v3 domain.
BR…
Part Number: AM6442
Problem Description
The MCU+ SDK comes with a GPIO_INPUT_INTERRUPT example for R5FSS0-0. This example configures a GPIO pin to generate an interrupt and then registers an interrupt handler to service the GPIO interrupt. This example…
Part Number: SK-AM62
What is GPIO?
The General-Purpose Input/output (GPIO) peripheral provides dedicated general-purpose pins that can be configured as either inputs or outputs.
GPIO can be used in three modes:
*Input
*Output
*Interrupt
…
Part Number: TMS320C6678 Other Parts Discussed in Thread: CCSTUDIO How to set Static and DHCP IP configuration using PDK in C667x and C665x family Processors ?
