TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198340 Discussions
  • Not Answered

    SD Card examples in C55XCSL_LOWPOWER_2.10.00.00 0 Locked

    2197 views
    26 replies
    Latest over 14 years ago
    by Hyun Kim
  • Answered

    Which app and codec examples should I pattern after? 0 Locked

    404 views
    4 replies
    Latest over 14 years ago
    by Helmut Forren
  • Not Answered

    Can't use L2 ram on C6A816x 0 Locked

    335 views
    4 replies
    Latest over 14 years ago
    by CC46425
  • Not Answered

    DMT transciever 0 Locked

    908 views
    3 replies
    Latest over 14 years ago
    by RandyP
  • Not Answered

    Can't connect to C6A816x 0 Locked

    374 views
    3 replies
    Latest over 14 years ago
    by Günter
  • Answered

    VUI fixed_frame_rate_flag 0 Locked

    1644 views
    3 replies
    Latest over 14 years ago
    by Yashwant Dutt
  • Not Answered

    How can I use G.711 file converted by DM365? 0 Locked

    366 views
    1 reply
    Latest over 14 years ago
    by Cesar
  • Not Answered

    Problem to connect to PADK with XDS510USB JTAG Emulator using CCSv4. 0 Locked

    1027 views
    7 replies
    Latest over 14 years ago
    by Fredrik Samuelsson
  • Not Answered

    ActiveSync and serial cable connection on 3530 EVM 0 Locked

    361 views
    1 reply
    Latest over 14 years ago
    by Kuzmin Alexey
  • Answered

    OMAP35x BSP: PowerVR OpenVG support - version 1.0 or 1.1? 0 Locked

    421 views
    3 replies
    Latest over 14 years ago
    by Gary Tominovich
  • Not Answered

    Remote node creation FAILED 0 Locked

    246 views
    0 replies
    Started over 14 years ago
    by meng zhou
  • Not Answered

    how to interface cell phone with the DSK TMS320C6713 processor 0 Locked

    164 views
    0 replies
    Started over 14 years ago
    by ramya puvvada
  • Not Answered

    DSP bridge OMAP3530 Android Froyo not working 0 Locked

    393 views
    2 replies
    Latest over 14 years ago
    by Mitnick
  • Not Answered

    SPI Code Samples 0 Locked

    308 views
    3 replies
    Latest over 14 years ago
    by PaulM
  • Not Answered

    How to recompile codec_engine_xy_y_x libraries? 0 Locked

    106 views
    0 replies
    Started over 14 years ago
    by FabF
  • Not Answered

    Question on YCrCb Demultiplexing for DM6437 0 Locked

    199 views
    0 replies
    Started over 14 years ago
    by Cheah Hun Oon
  • Answered

    Loading Program into 6713B 0 Locked

    360 views
    2 replies
    Latest over 14 years ago
    by Bilal Goraya
  • Answered

    error creating SIO stream 0 Locked

    2926 views
    20 replies
    Latest over 14 years ago
    by Royke
  • Not Answered

    EVM6467T steady "sub-framing" (12 fps) when encoding PAL@50hz 0 Locked

    336 views
    0 replies
    Started over 14 years ago
    by natxominambres
  • Discussion

    DM365 hangs up when video stream has missing frames Locked

    1749 views
    12 replies
    Latest over 14 years ago
    by Jun Yang64790
<>