Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] DRA821U: How to use DDR BIST engine for filling up pattern.

    Part Number: DRA821U Other Parts Discussed in Thread: DRA821 Dear support, For DDR ECC per-load, we use the BIST engine for SDRAM initilization, but it fails, the following is the registers configured, Could you help me check whether the configuration…

  • [FAQ] DRA821U: Test on SDK8.1 for Ethernet Firmware

    Part Number: DRA821U Hi Champs There're questions about Ethernet Firmware Test on SDK8.1 release. My customer has tried to activate 4-ports of CPSW-5g on top of SDK 8.1-prebuilt image. They found issues below. (with followings were executed…

  • [FAQ] TDA4VM: Large size of tispl.bin after integrating custom DM firmware for MCU R5

    Part Number: TDA4VM Other Parts Discussed in Thread: TI-CGT I have updated the Linux SDK top level Makefile to add my custom firmware for MCU1_0 (MCU R5). As I understand the path to the ELF image needs to be set as UBOOT_DM in the Makefile. But after…

  • [FAQ] TDA4VM: Not able to receive messages for a particular CAN ID, how to debug?

    Part Number: TDA4VM I am using MCAL CAN driver and able to transmit any message from the TDA4 using MCU MCAN0. However when I try to receive messages for a particular CAN ID from an external CAN emulator, I am not getting that on the TDA4's MCU MCAN0…

  • [FAQ] 66AK2E05: How to load and run the ARM gel file on K2E EVM

    Part Number: 66AK2E05 Hi, How to load and run the ARM gel file on K2E EVM ?

  • [FAQ] 66AK2E05: How to load and run the DSP gel file on K2E EVM

    Part Number: 66AK2E05 Hi, How to load and run the DSP gel file on K2E EVM?

  • [FAQ] 66AK2E05: How to create "Target configuration" and do "Test connection" on K2E EVM.

    Part Number: 66AK2E05 Hi, How to create "Target configuration" and do "Test connection" on K2E EVM?

  • [FAQ] TMS320C6657: How to load and run the DSP gel file on C6657 EVM

    Part Number: TMS320C6657 Hi How to load and run the DSP gel file on C6657 EVM ?

  • [FAQ] TMS320C6657: How to create "Target configuration" and do "Test connection" on C6657 EVM

    Part Number: TMS320C6657 Hi, How to create "Target configuration" and do "Test connection" on C6657 EVM ?

  • [FAQ] AM6254: Monitor pins

    Do the MON_1P8 3P3 ER_VSYS pins have a functional meaning or are these simply ADCs which can be read out by the CPUs for diagnostic purposes? Regards Bernd

View FAQ threads
  • Threads 197627 Discussions