TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot u-boot from parallel GPMC NAND on AM64x

    Hong Guan64
    Hong Guan64
    Part Number: AM6442 Other Parts Discussed in Thread: TMDS64EVM Tool/software: AM64x boot ROM supports booting from parallel GPMC NAND. From "4.4.10 GPMC NAND Boot" in AM64x TRM "AM64x ROM only supports boot from ONFI 1.0 compatible 8 bit parallel…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198019 Discussions
  • Not Answered

    For some functions of APIs in the VICP signal processing library, there is some questions 0 Locked

    382 views
    2 replies
    Latest over 16 years ago
    by kathy
  • Discussion

    How to use XDS 510 USB & BH-USB-560 JTAG emulators with CCS3.3.38.2 + 6437EVM? Locked

    668 views
    4 replies
    Latest over 16 years ago
    by Eric Fang
  • Not Answered

    about h.264 on dm6446 0 Locked

    504 views
    5 replies
    Latest over 16 years ago
    by Venugopala
  • Discussion

    Memory Cache Usage on DM6437 Locked

    410 views
    3 replies
    Latest over 16 years ago
    by teddy9483
  • Not Answered

    creating video output channe 0 Locked

    414 views
    2 replies
    Latest over 16 years ago
    by Vadim
  • Discussion

    Using mpeg4 and jpeg encoder from kernel Locked

    245 views
    2 replies
    Latest over 16 years ago
    by Constantine
  • Not Answered

    Modified DVEVM6446 to accept Component Video Input 0 Locked

    1332 views
    2 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    dm6467 vlynq speed Locked

    281 views
    3 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    xc4vsx35(xevm642) and dm642 dsp Locked

    317 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    transmit data to mount hdd with the DMA channel on the DM355 EVM ? Locked

    304 views
    4 replies
    Latest over 16 years ago
    by Jignesh Shah
  • Not Answered

    UART1 vs UART3 for console and periph booting on OMAP35x 0 Locked

    849 views
    4 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    how to process floating-point data on DSP side (DM6446)? 0 Locked

    1806 views
    12 replies
    Latest over 16 years ago
    by Gagan Maur
  • Not Answered

    What is Frame in ASP ? 0 Locked

    968 views
    11 replies
    Latest over 16 years ago
    by Simon Wu
  • Discussion

    using the video_prieview as RGB 565 Locked

    347 views
    2 replies
    Latest over 16 years ago
    by MattLipsey
  • Discussion

    why the dm6446 dsp cpu load is so high(90%) while doing simple calculation? Locked

    388 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    system crashed when run Xserver 0 Locked

    1989 views
    3 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    using the videw_preview 0 Locked

    337 views
    4 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    how to get a small *.out file Locked

    199 views
    2 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    Cache hits & misses Locked

    616 views
    5 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    Encoding issue on OMAP3530 0 Locked

    215 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
<>