TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198359 Discussions
  • Not Answered

    XDS560R Code Composer does not support the connected target 0 Locked

    1136 views
    9 replies
    Latest over 16 years ago
    by Mark20
  • Discussion

    Problem Building a New Kernel (4.5) Locked

    569 views
    2 replies
    Latest over 16 years ago
    by Ioan
  • Not Answered

    DM355 and CMOS 0 Locked

    317 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    about video clips conversion on dm355 Locked

    384 views
    2 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Answered

    New devices: C674x family 0 Locked

    342 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    New OMAP-L137 Live Q&A 0 Locked

    253 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    running demo codes encode and decode on a DM355 Locked

    820 views
    8 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    Need info in interrupts Locked

    421 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    Problem with Engine.cfg ! 0 Locked

    489 views
    7 replies
    Latest over 16 years ago
    by KAKA
  • Discussion

    about DM355 cmos sensor issue! Locked

    364 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    audio test Locked

    301 views
    3 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    DM648 EVM video driver lockup 0 Locked

    813 views
    9 replies
    Latest over 16 years ago
    by chris2476
  • Not Answered

    Gstreamer Synchronisation - Davinci 6446 0 Locked

    217 views
    0 replies
    Started over 16 years ago
    by MuthuKumar
  • Discussion

    C6424 compared to DM6437. Similar enough to run DSP/BIOS Link on C6424? Locked

    287 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    DM6437 PCI master single write trouble Locked

    314 views
    2 replies
    Latest over 16 years ago
    by Guy
  • Not Answered

    running demo codes encode and decode on a DM355 0 Locked

    660 views
    7 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    c6727 SPI slave boot mode problem Locked

    2408 views
    13 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    OMAP35x interface to Mobile DDR 0 Locked

    297 views
    2 replies
    Latest over 16 years ago
    by Howard Robson
  • Not Answered

    How can I get GPIO0 interrupt to occur in rising edge on DM6446? 0 Locked

    324 views
    2 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    Problem with Gstreamer - Thread switching 0 Locked

    435 views
    2 replies
    Latest over 16 years ago
    by Juan Gonzales
<>