TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198296 Discussions
  • Not Answered

    Capture Frame (Skipped Frame logic) 0 Locked

    265 views
    1 reply
    Latest over 13 years ago
    by Brijesh Jadav
  • Answered

    problems building qt with tslib 0 Locked

    3430 views
    5 replies
    Latest over 13 years ago
    by dj42901
  • Discussion

    C674x FreeRTOS port Locked

    663 views
    0 replies
    Started over 13 years ago
    by Dmitry
  • Answered

    Slaveloader missing file ! 0 Locked

    530 views
    7 replies
    Latest over 13 years ago
    by MALAUD Baptiste
  • Answered

    Boot order and board init 0 Locked

    1425 views
    5 replies
    Latest over 13 years ago
    by Mark K
  • Not Answered

    SPS/PPS H.264 Parameters 0 Locked

    631 views
    0 replies
    Started over 13 years ago
    by Charles McCallum
  • Answered

    Building FrameQ four core application 0 Locked

    2819 views
    13 replies
    Latest over 13 years ago
    by Arnie Reynoso
  • Not Answered

    OMAP3530 MUSB OTG: usb-to-ethernet link goes down sporadically 0 Locked

    270 views
    2 replies
    Latest over 13 years ago
    by Kalaiselvan Rajagopal
  • Not Answered

    Square pixel mode VPIF 0 Locked

    116 views
    0 replies
    Started over 13 years ago
    by Vladimir Manannikov
  • Not Answered

    Does the power-off sequence happen some effects on next power-on on DM355? 0 Locked

    189 views
    0 replies
    Started over 13 years ago
    by RY9983
  • Not Answered

    Is there a GB 2.3.4 with dsp release planned for the DM37xx? 0 Locked

    589 views
    6 replies
    Latest over 13 years ago
    by Juan Garibay87970
  • Answered

    Sound Recorder App File Playback 0 Locked

    817 views
    7 replies
    Latest over 13 years ago
    by Chris Read
  • Not Answered

    Picture-in-Picture on Davinci DM6446 0 Locked

    220 views
    2 replies
    Latest over 13 years ago
    by VENKAT47948
  • Not Answered

    The AAC audio codec problem on DM6467 platform 0 Locked

    166 views
    0 replies
    Started over 13 years ago
    by xu zhang
  • Answered

    AM389x Ethernet Boot Procedure - Link Speed Issue 0 Locked

    308 views
    2 replies
    Latest over 13 years ago
    by audioman
  • Answered

    H.264 Decoder problem with SD 576i(726 x 288) streams 0 Locked

    937 views
    10 replies
    Latest over 13 years ago
    by Mahantesh S Madiwalar
  • Not Answered

    Serious Question about RDK Version 01.05.00.08 0 Locked

    370 views
    4 replies
    Latest over 13 years ago
    by Frank Lin78331
  • Not Answered

    Removing Mouse Cursor - DM365 RDK 0 Locked

    217 views
    0 replies
    Started over 13 years ago
    by CC Lin
  • Answered

    How to use interrupt at PWRGIO[6:3] (Number 29?) with dm365 except PWRCTRIO[2:0] mapped as GIO[104:106] 0 Locked

    1742 views
    18 replies
    Latest over 13 years ago
    by ravi chandran
  • Not Answered

    How to echo debug messages to console for init scripts? 0 Locked

    597 views
    0 replies
    Started over 13 years ago
    by Hao Liu48112
<>