TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – SDIO (embedded) interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300 Tool/software: Hi TI Experts, Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198171 Discussions
  • Answered

    SmartReflex on DM3730EVM 0 Locked

    731 views
    7 replies
    Latest over 14 years ago
    by Kanae
  • Not Answered

    c64x EMAC TX Interrupt Delay 0 Locked

    308 views
    1 reply
    Latest over 14 years ago
    by dabuan
  • Not Answered

    installation procedure for dm365 0 Locked

    251 views
    4 replies
    Latest over 14 years ago
    by vigneshwaran sekar
  • Not Answered

    OMAP-L138 EMIFA Asynchronous Device 0 Locked

    323 views
    1 reply
    Latest over 14 years ago
    by dabuan
  • Not Answered

    Connection ADS1178 to OMAP-L137 0 Locked

    296 views
    2 replies
    Latest over 14 years ago
    by dabuan
  • Answered

    TMS320C6678 availability 0 Locked

    234 views
    1 reply
    Latest over 14 years ago
    by Chad Courtney
  • Answered

    c6678 Internal Temperature and Current Sensor 0 Locked

    1263 views
    2 replies
    Latest over 14 years ago
    by r_robotics
  • Answered

    Video DAC Vref 0 Locked

    242 views
    1 reply
    Latest over 14 years ago
    by MarcPyne
  • Not Answered

    Power management example and Power and Sleep Controller on DM365 0 Locked

    334 views
    2 replies
    Latest over 14 years ago
    by renfeng zhou
  • Answered

    pin not match with EVM1808 DDR2 connection 0 Locked

    236 views
    1 reply
    Latest over 14 years ago
    by jc-ti
  • Not Answered

    Getting started with AM35x Linux - couple of newbie questions.. 0 Locked

    174 views
    0 replies
    Started over 14 years ago
    by Gary Marsh
  • Discussion

    DSP/Link - Heavy use of DSP/Link, Linux and DSP/BIOS crashes, are they related? Locked

    577 views
    2 replies
    Latest over 14 years ago
    by TSC
  • Answered

    AM3517 DDR2 Cycle time 0 Locked

    440 views
    5 replies
    Latest over 14 years ago
    by CharlieWW
  • Not Answered

    data verification failed 0 Locked

    292 views
    6 replies
    Latest over 14 years ago
    by Varada Bellary
  • Not Answered

    UPP interrupt C6748 0 Locked

    1804 views
    17 replies
    Latest over 14 years ago
    by Joe Coombs
  • Not Answered

    Expected DM365 ADC input impedance? 0 Locked

    321 views
    3 replies
    Latest over 14 years ago
    by Marcus Cooksey
  • Not Answered

    xdc.runtime.Error.raise: terminating execution 0 Locked

    4277 views
    5 replies
    Latest over 14 years ago
    by David Friedland
  • Suggested Answer

    Can OSD scale to meet the video resolution in DM365 ? 0 Locked

    418 views
    1 reply
    Latest over 14 years ago
    by Nagabhushana
  • Answered

    How to manage TPS65950 by I2C (or any other methods)? 0 Locked

    753 views
    3 replies
    Latest over 14 years ago
    by Gil Zhaiek
  • Answered

    Cannot run the Genserver Wizard in CCS4.2.3 0 Locked

    462 views
    5 replies
    Latest over 14 years ago
    by Lee Holeva
<>