when i use a csi2 rx subsystem in xilinx zynq processor, csi2 have some pixel formate ,The following figure:
Which one should i choose?what document can i refer?
thank you.
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi,
The hw team will review this question and get back to you
Due to Summer vacations there will be some delays in the response.
thank you
cesar
It depends on the configuration set on the AWR2243 side. If you set 16bit ADC mode, RAW8 mode is used. If you set 12bit ADC mode RAW12 is used , in 14 bit ADC mode RAW14 is used.
Regards,
Vivek