TMCS1100-Q1: TMCS1100-Q1 selection

Links

Part Number: TMCS1100-Q1

Dear experts,

We need to measure the voltage value corresponding to the forward current (20mA~7A) and the voltage value corresponding to the reverse current (about - 30mA) to distinguish, and then judge whether to turn off the output
Can TMCS1100-Q1 chip be used.

Best regards,
William

over 2 years ago

0 Carolus Andrews over 2 years ago

TI__Mastermind 19040 points

William,

The challenge here will be on the smaller ends of current. Hall sensors are inherently noisy devices, and as such are not great for small measurements. How much resolution does the customer need at the lower ends of measurement here?

0 Links over 2 years ago in reply to Carolus Andrews

TI__Intellectual 2930 points

The reverse current is about - 30mA. A dead load of - 10~- 20mA can be added to the front end. The minimum forward current is about 20mA

just okay if it can measure the change of 50mA

Best regards,
William

0 Carolus Andrews over 2 years ago in reply to Links

TI__Mastermind 19040 points

Jiahui,

The challenge here as I mentioned earlier is going to be the noise floor of the device. For example if you used the A4 variant, the noise density of this device is 225 uA/sqrt(Hz). Over the full BW, this calculates to 63.6mArms, which means your measurement is going to be right around the noise floor of the device on the lower ends. You can, however, throttle the BW of the device to lower this value to something you may be able to accept for the application.

Sensors

Sensors forum

TMCS1100-Q1: TMCS1100-Q1 selection