HDC2022: Reading data from multiple sensors through I2C multiplexer

Dear Veera - 

Thanks for the post! 

Here you would need to (on each loop through each channel) replicate your code for address 0x40, and add address 0x41 subsequent to polling for 0x40. Then you would want to command your PCA9548 to switch channels and repeat that loop. (as the default state of the PCA device channel is all disabled, so I am assuming you commanded it to a specific channel, as you stated you were able to communicate with the device at 0x40 already.) Then switch and loop six more times to capture data from all 16 devices. 

Specifically, for the mux, to address next channel (if you started with Channel 0 of the PCA9548 using command byte 0x01), you would send 0x02, to turn on Channel 1 and turn off Channel 0.  See pages 16 & 17 here: https://www.ti.com/lit/ds/symlink/pca9548a.pdf 

Veera - 

Please find attached and image below for assisting you into organizing your code to accomplish setting up and using the parts via the mux. 

4745.HDC2_PCA9548_Mux_logic.pdf

Veera -

I was able to dig up a MEGA 2560 and put this sketch together for you, which is a one second loop read of two HDC2 sensors, one on address 0x40, the other on 0x41. I tested this on my side with hardware I had. You will still need to add the PCA specific code & loop, and of course test. Please do let me know if you get it working / or get stuck by replying or reposting.  

0x40_0x41_HDC20xx_Example_12_2022.ino

This is the output, on UART, so you can log it as a csv, with a timestamp added by the terminal up front, and still comma separated correctly