Other Parts Discussed in Thread: OPT4001
Hello Expert,
Would you answer following question?
- Could you explain how to calculate lux from measured result on register using example?
Datasheet has explanation but it is using some digital calculation as like as << and 400E-6.
It make's difficulty of understand.
Therefore, please explain the calculation using example. - Could you explain criteria of change measurement range at auto range mode?
Datasheet's explanation using unclear words as like as toward the low/upper side, decreasing one or two, and so on...
Therefore, we cannot understand when range update happen.
So I need more clear criteria and explanation to understand the auto range behavior. - How long will it take to restart the measurement using update range in continuous mode?
Datasheet's explanation seems that it restart measurement immediately if it detect saturation of measurement range.
However, I cannot how long it will take to restart measurement.
We need this value to make decision of their register read cycle in continuous mode.
Thank you and best regards,
Kazuki Kuramochi