• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 30 subscribers
  • Views 51 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TUSS4470: BOOSTXL-TUSS4470 - Unable to Activate Device Status Bits O4 Pin and O3Pin

Dror Gershon
Prodigy 20 points
Part Number: TUSS4470

Hi , 

We are running the EVB  and are Unable to get O4,O3 Status bits indications changing   .

What are we missing ? 

See  attached screenshot showing the Data Monitor and Registres Configuration .

Many thanks for your help 

Dror 

  • 0
    TI__Expert 8055 points

    Hi Dror,

    Thank you for posting to the Sensors forum!

    Looking at your current configuration, it looks like you have ZC_CP_EN set to disabled. This bit will need to be enabled in order for a zero-crossing signal to output on the OUT3 pin.

    If enabling ZC_CP_EN doesn't help, would it be possible to get a waveform capture of OUT3 and OUT4 during this operation, just to see if a signal is being output on these pins.

    Best,

    ~Alicia