Other Parts Discussed in Thread: MMWCAS-RF-EVM
Tool/software:
I'm trying to collect radar data with the MMWCAS-DSP-EVM board and the MMWCAS-RF-EVM radar, but I'm having troubles setting up the system initially.
I'm following this guide on how to set up the board (https://software-dl.ti.com/ra-processors/esd/MMWAVE-STUDIO/latest/exports/mmwave_studio_cascade_user_guide.pdf) that I got from this related forum (https://e2e.ti.com/support/sensors-group/sensors/f/sensors-forum/1338104/mmwcas-dsp-evm-is-there-any-organized-quick-start-document). I follow this guide, not the standard one, as I am having problems with the mmWaveStudio detecting the radar, even when it's plugged in. The only 2 ports are detected, not 4 as mentioned on the standard guide, so I'm following the Cascade user guide. But I'm stuck following the instructions there too.
I am able to follow the guide until section 7 Device Configuration (mmWaveStudio). However, I cannot find where the menu in 7.1 is present in the mmWaveStudio, I've included it below:
The screenshot in the guide is cropped such that I cannot see which menu the options are in. I installed the mmWaveStudio-2G, as said on the website. But I cannot find anywhere in the application "Single Chip" Radar System selection, or any of the options/buttons that are seen on the image. Could you please advise me where I can find this menu, and if these steps are the right ones for the set-up I'm trying to run?
Thanks,
