HDC1080EVM: Two boards on one GUI

Basil

Part Number: HDC1080EVM
Other Parts Discussed in Thread: HDC1080

Dear Team,

is it possible to connect two HDC1080EVMs with one PC and run measurements from both sensors on one single Sensing Solutions EVM GUI Tool?

Thanks and best regards,

over 6 years ago

0 Jose Arteaga4 over 6 years ago

TI__Expert 5695 points

Hi Basil,

The Sensing GUI Solutions used on large number of sensing products (including HDC1080) do not support multiple devices. It supports one EVM at the time.

What we do have is Arduino based SW example with training video in the link below that will enable to have a low cost setup with minimal effort.
www.ti.com/.../support

Regards,
Jose

Sensors

Sensors forum

HDC1080EVM: Two boards on one GUI