LMT01EVM: LMT01EVM Auto Connect Failed

Don Foong

Expert 4100 points

Part Number: LMT01EVM

Hi Team,

Our customer encounter GUI message as below, can you help to advise what should be done to get pass ? Thanks.

Look forward to your feedback.

Thanks and regards,

Don

over 5 years ago

0 Josh Wyatt over 5 years ago

TI__Guru* 91166 points

Dear Don -
can you check your device manager (on PC) to see which com port the EVM enumerated to? (see figure 7 on page 8 here www.ti.com/.../sniu027a.pdf)
then also, after you hit 'OK' in the window above, are you able to use drop down in serial port window and connect that way?

0 Don Foong over 5 years ago in reply to Josh Wyatt

TI__Expert 4100 points

Hi Josh,

After hit 'OK' in the window above, there is nothing shown from the drop down in serial port window.

The EVM enumerated as 'MSP430-USB Example'.

Do you think updating the device driver would help, do you have the LMT01EVM device driver to share ? Thanks.

Regards,

Don

0 Josh Wyatt over 5 years ago in reply to Don Foong

TI__Guru* 91166 points

Don -

any chance you could unplug the EVM, reboot the computer and then have a look again?

also, the LMT01EVM_DRIVER.inf file is here ==> C:\Program Files (x86)\Texas Instruments\LMT01EVM\Firmware

0 Don Foong over 5 years ago in reply to Josh Wyatt

TI__Expert 4100 points

Hi Josh,

Yes, the LMT01EVM is working now. Thanks for the support.

Regards,
Don

Sensors

Sensors forum

LMT01EVM: LMT01EVM Auto Connect Failed