• State Resolved
  • Locked Locked
  • Replies 4 replies
  • Subscribers 16 subscribers
  • Views 991 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TS3USB221 PSRR?

NAOKI AOYAMA
Guru 11215 points
Other Parts Discussed in Thread: TS3USB221

Hello,

Our customer uses the TS3USB221, has a question.

How about the PSRR characteristic of this device?

I think that the power supply have no impact on signal integrity.

Regards,

Naoki Aoyama

  • 0
    TI__Mastermind 45495 points
    Naoki,

    Correct, the power supply will have little impact on signal integrity but it is always good practice to place a bypass capacitor close to the ICs power supply pin.

    Like most of TI signal switches the TS3USB221 signal path is a simple pass FET from the drain to the source. Since this signal path is not buffered, we do not specify the PSRR in the datasheet or expect there to be much impact on signal integrity.

    How much noise is on your power supply that you are concerned about? Is this for a USB2.0 application?

    Thank you,
    Adam
  • 0 in reply to Adam Torma
    Guru 11215 points
    Hello Adam,

    Thank you for your reply.
    The customer wanted to know the requirement for power supply quality.
    How much the value of the bypass capacitor? 0.1uF?

    Thanks,
    Naoki Aoyama
  • 0 in reply to NAOKI AOYAMA
    TI__Mastermind 45495 points

    Naoki,

    Yes, a 0.1uF bypass capacitor is fine for the TS3USB221 device. 

    Thank you,

    Adam

  • 0 in reply to Adam Torma
    Guru 11215 points
    Hi Adam,

    Thank you for your reply.
    I will feedback the customer this information.

    Thanks,
    Naoki Aoyama