This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: TS3A4751
My customer would like to use TS3A4751/TMUX1111 in the battery supply application, Vbat=3.4V to 4.4V. VIO=1.8V
From the application note , we can see if the I/O voltage is lower than Vbat, the supply current is increased.
Need your help to check whether these two devices is same as the behavior that application note says. Thanks!
The TS3A4751 has a recommend max of 3.6V on the supply pin and should not be used if Vbat can go as high as 4.4V.
The TMUX1111 can handle the supply voltages mentioned in your post.
Just to verify - when you say VIO=1.8V do you mean the voltage on the logic control inputs (SELx)? Or are you talking about the signals on the input/output path of the TMUX1111 (S and D pins)?
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Dakotah:
For TS3A4751 , we can set input voltage to 3.3V input. The VI/O means the logic input like IN1 to IN4.For TMUX1111 , we can set input voltage to battery. The VI/O means the logic input like SEL1 to SEL4
Need your help to check whether power consumption is increased in this condition. Thanks!
In reply to Hisen Zhang:
Yes the current consumption will increase if using 1.8V logic on the logic pins.
Here is an image from the TMUX1111 datasheet which shows the supply current vs logic voltage.
For a 3.3V supply and a 1.8V logic signal - the current would increase to ~220uA.
What is the supply current budget in the system? Is 220uA acceptable?
If customer can use the 3.3V VDD voltage, Need your help to check if IN1 to IN4 pin is 1.8V, VDD voltage is 3.3V, does the device TS3A4751 supply current also increase?
In reply to Adam Torma:
I tested a few devices in the lab today and the TS3A4751 current does increase if VDD=3.3V and IN1 to IN4 are at 1.8V.
In this case the current increases to 2.5mA, where the TMUX1111 current increases to 220uA.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.