Other Parts Discussed in Thread: MSP-FET, MSP-FLASHER
Tool/software: Code Composer Studio
Hi,
I'm using the MSP-TS430RGC64USB with MSP-FET.
When I connect my MSP-FET to CCS 10.0, it starts configuring Debugger, it says (Error initializing emulator. A firmware update is required). Upon clicking update, it starts the update process but then it shows me an error that says "Error initlziating emulator, could not set device Vcc". I looked up solutions, and it said try to use the MSP-Flasher. When I run the MSP-Flasher, this is the error that pops up.
C:\ti\MSPFlasher_1.3.19>MSP430Flasher.exe -w "Firmware.txt" -v -g -z [VCC]
* -----/|-------------------------------------------------------------------- *
* / |__ *
* /_ / MSP Flasher v1.3.19 *
* | / *
* -----|/-------------------------------------------------------------------- *
*
* Evaluating triggers...done
* Checking for available FET debuggers:
* Found USB FET @ COM6 <- Selected
* Initializing interface @ COM6...done
* Checking firmware compatibility:
* FET firmware is up to date.
* Reading FW version...done
* Setting VCC to 3000 mV...done
* Accessing device...
# Exit: 16
# ERROR: Unknown device
* Starting target code execution...done
* Disconnecting from device...done
*
* ----------------------------------------------------------------------------
* Driver : closed (Internal error)
* ----------------------------------------------------------------------------
*/
As you can see, there's conflicting information from CCS and MSPFlasher, CCS says I need an update, Flasher says I do not but then fails.
How can I go about fixing this?
Thanks.