Trouble writing memory block, MSP430G2352

Bob Shaw

Other Parts Discussed in Thread: MSP430G2211, MSP430G2352

I am using CCS V4.3.4.00033 with the TI LaunchPad (MSP-EXP430G2). The LaunchPad shipps with an MSP430G2211. I ran the "blinking LED" code example, no problem. I added some additional code associated with port P1, still ran with no problem. I built a new project, using my previous code, less the blinking LED part, changed the target to MSP430G2352 in both hardware and in the project hardware definition (my *.ccxml file does shoe MSP430D23252). It compiled fine but when I go to debug it, I get the following error -

MSP430: Trouble Writing Memory Block at 0xfffe on Page 0 of Length 0x2: Could not write device memory

Cannot write to target

A reply would be appreciated.

Thanks, Bob Shaw

over 12 years ago

0 JohnS over 12 years ago

TI__Guru**** 160230 points

Bob,

Did the linker command file change as well or is it still setup for G2211?

John

0 Lisa TI over 12 years ago in reply to JohnS

TI__Guru*** 130875 points

Hi Bob,

could you please also check the included header file. Are you using msp430.h? Or a specific one that might need updating? You may have done this as well.

Best Regards,
Lisa

0 Bob Shaw over 12 years ago in reply to Lisa TI

Prodigy 70 points

Thanks for the response. The problem has been solved - it did involve the header file, but was due to 'punctuation' - quotes instead of carats. And of course, having an update come through while I was in the middle of this did not help.

Bob

0 Lisa TI over 12 years ago in reply to Bob Shaw

TI__Guru*** 130875 points

Hi Bob,

happy new year and glad to hear you managed to figure things out.

Best Regards,

Lisa

Code Composer Studio™︎

Code Composer Studio forum

Trouble writing memory block, MSP430G2352