Other Parts Discussed in Thread: UNIFLASH
Tool/software: Code Composer Studio
Hello,
I'm new to working with TI MCU's. I'm trying to save from and write to the Flash Memory of a MSP430F135 MCU using the MSP-FET430UIF V1.4A and UniFlash V4.6.0.2176 on Windows 10.
I'm not exactly sure what part of the memory I am to save. I was successful at saving the memory from 0x0 to 0x3FFF as a .bin file (16KB, the Max Flash Memory size). I performed a Mass Erase of the device. I then Loaded the bin file with the "Binary:" checked but "Address:" blank (I don't know what to enter) and get the following errors:
[ERROR] MSP430: Trouble Writing Memory Block at 0x0 on Page 0 of Length 0x4000: Could not write device memory
[ERROR] MSP430: File Loader: Verification Failed: Target failed to write 0x0000
I entered value 0x3FFF in "Address:" but get the following error:
[ERROR] MSP430: File Loader: Verification Failed: Values at address 0x3FFF do not match Please verify target memory and memory map.
I think I'm saving it wrong. Can someone please help me with this? Thank you in advance.
Roger