Generating (Codes VS Samples) or (Voltage VS Samples) Graphs

David Tandri

Other Parts Discussed in Thread: ADS8681

Hi,

I would like to simulate ADS8681 on TINA TI to generate this graph (refer to the screenshot). This graph was generated using ADS8681 EVM board with our front end circuitry connected to the board and captured by the ADC software.

How do I generate this same graph (Codes VS Samples) or (Voltage VS Samples) on TINA TI?

Thanks

over 3 years ago

0 David Tandri over 3 years ago

Expert 1355 points

Sorry for posting the same topic multiple times. When I pressed "Post" the page was just loading and loading, I thought it was not posted.

Actually, it has succesfully been posted.

0 LeonardEllis over 3 years ago

TI__Guru 71536 points

Hello David,

Thank you for your inquiry about TINA. Since TINA is a DesignSoft/TINA program, questions are handled by using the DesignSoft support page: http://www.tina.com/technical-support/ .

The DesignSoft/TINA team is very helpful and this is the most direct way for TINA support. Please advise by Reply when the issue has been resolved.

Regards,

~Leonard

(also, the duplicate thread has been deleted)

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

Generating (Codes VS Samples) or (Voltage VS Samples) Graphs