TIDA-020047: Min hole from 0.15mm to 0.2mm

Amine LTAIEF

Intellectual 505 points

Part Number: TIDA-020047

Hi,

I was wondering if My manufacturer can move the Min hole size from 0.15mm to 0.2mm

Regards

Amine

5 months ago

0 Amine LTAIEF 5 months ago

Intellectual 505 points

Hi please any answer for this.

Regards

0 Brian Shaffer 5 months ago in reply to Amine LTAIEF

TI__Intellectual 1130 points

Hi Amine,

There is not an electrical reason that you could not increase the drill sizes. However, you will need to ensure that this does not cause other problems with the artwork. This might include things like via pad breakout, inadequate annular ring, etc.

Brian

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

TIDA-020047: Min hole from 0.15mm to 0.2mm