LAUNCHXL-CC13-90: Smart RF studio and custom CC1300 + CC1190 board?

AnBer

Part Number: LAUNCHXL-CC13-90
Other Parts Discussed in Thread: CC1190, , CC1310, CC1352R

Team,

It seems that the LAUNCHXL-CC13-90 (CC1300 + CC1190) is supported out of the box in Smart RF studio.

However using Smart RF studio with a custom CC1310 + CC1190 board:
how can the CC1190 be enabled in RF studio?
Are there some XML files that can be used?

Thanks in advance,

over 3 years ago

0 Vegard H over 3 years ago

TI__Expert 4560 points

You can select the DIOs to be used with the CC1190 device by going to the custom target configuration found here:

Vegard

0 AnBer over 3 years ago in reply to Vegard H

TI__Mastermind 29150 points

Hi Vegard,

Thanks!

What if the custom board is based on CC1352R + CC1190?
What should be taken for "RF design Based On"? The LPXL-CC1310-CC1190 or the CC13x2R LP?

In RF studio will the CC13x2 underlying SW be managing the CC1190 in the same as the CC1310 SW?

I have see the below post as well:
https://e2e.ti.com/support/wireless-connectivity/sub-1-ghz/f/156/p/901664/3334770#3334770
Is it enough in "Hardware Configuration window" to select the pin used for the CC1190? or are there some more changes to do?

Thanks in advance!

0 TER over 3 years ago in reply to AnBer

TI__Guru**** 317180 points

If you use a CC1352R, "CC1310-CC1190" is not an option under "RF design Based On". You have to select a board that is closest to the implementation of the CC1352R part of the board. In addition you have to add control for the PA_EN/ LNA_EN lines by adding the lines describes in chapter 4 in https://www.ti.com/lit/an/swra542/swra542.pdf. The actual DIO number is dependent on their board implementation.

Use a logic analyzer or similar to verify.

Sub-1 GHz

Sub-1 GHz forum

LAUNCHXL-CC13-90: Smart RF studio and custom CC1300 + CC1190 board?