UHF rfid Reader

Hello Kalpesh, 

What is the question?  

Thank you,

~Leonard  

Can i use this design for uhf rfid reader

CC1190 is added to increase range. Can this work for this purpose?

Yes.

So Can i go for commercial market with this design. The link you share is Private

Meaning that you are not able to open the link? 

Yes i am unable to open content in link.

I'm able to open the link ( https://e2e.ti.com/support/wireless-connectivity/sub-1-ghz/f/sub-1-ghz-forum/57751/uhf-rfid-reader-with-cc1101-and-msp430) on a PC where I'm not logged in or have opened this link before. Not sure why you see issues. 

Did my schematic work for UHF rfid reader or please suggest the changes require in design. So i can continue on remaining design.

I'm not familiar with the current standard for active RFIDs. You have to check the standard and compare with the CC1101 datasheet. 

Could you also advice why you are looking at CC1101 + CC1190 and not CC1310 + CC1190 or some other combination? Without knowing the top level requirement it's difficult to answer the question. 

If you provide me information regarding CC1310 then i can work instead of CC1101. More over i am not familier with ti microcontroller programming.

See dev.ti.com/.../node