CC2650

Waseem Khan

Part Number: CC2531
Other Parts Discussed in Thread: CC2650, CC2538

Hello

I want to setup 6lbr to run 6LoWPAN (Sensortag CC2650) with a CC2531 USB dongle on Raspberry Pi. I am confused about where to start. How to make CC2531 usb dongle as the slip radio. From where I get hex file for CC2531 usb dongle.

over 3 years ago

0 Ryan Brown1 over 3 years ago

TI__Guru**** 211047 points

Hello Waseem,

Here are some resources to help get you started.

https://sunmaysky.blogspot.com/2015/08/setup-6lbr-to-run-6lowpan-with-cc2531.html
https://github.com/Steven1811/Texas-Instruments-CC2531-AT-Command-Firmware

Regards,
Ryan

0 Waseem Khan over 3 years ago in reply to Ryan Brown1

Prodigy 25 points

It help me a lot, but I didn't found the hex file for the CC2531 USB dongle. I am looking for a hex file of CC2531 USB Dongle. In [1], the hex file is given but it has been removed ago.

0 Ryan Brown1 over 3 years ago in reply to Waseem Khan

TI__Guru**** 211047 points

The processors Wiki is deprecated so you will need to find another site which is hosting this firmware. Contiki-OS appears to have CC253X support, or you can also check out the Contiki-NG project which includes CC2538 and SimpleLink (CC26XX / CC13XX) device support. Please note that TI does not maintain 6LoWPAN software solutions.

Regards,
Ryan

0 Waseem Khan over 3 years ago in reply to Ryan Brown1

Prodigy 25 points

Thank you!

I will go through this.

Zigbee & Thread

Zigbee & Thread forum

CC2650