• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 57 subscribers
  • Views 176 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

RF Serial boot loader

Furkan Fehmi Sefiloglu
Expert 3118 points
Other Parts Discussed in Thread: SYSCONFIG

Hi Team,

Can you please check and advise with request?

"

I am working on the RF Serial boot loader but it is not working. I followed the configuration that are in the attached document, but it is still not working.

In my setup:

I programmed the RF board with an image with the following configuration and latched “DIO_6” to the ground. Then restart the board to find the backdoor pin is active low so enter into the boot loader and run the SW application “sblAppEx.exe”. But it doesn’t work correctly. The configurations are as follow:

SET_CCFG_BL_CONFIG_BL_LEVEL=0x00

SET_CCFG_BL_CONFIG_BL_ENABLE=0xC5

SET_CCFG_BL_CONFIG_BL_PIN_NUMBER=0x06

SET_CCFG_BL_CONFIG_BOOTLOADER_ENABLE=0xC5

"

Thanks in advance

Best Regards

Furkan Sefiloglu

swra466c.pdf