CC2530: CC2530 interface with Host microcontroller

sanjay kumar

Part Number: CC2530
Other Parts Discussed in Thread: Z-STACK, CC-DEBUGGER

Dear all,

i have a cc2530 module which i need to interface with host microcontroller. i have installed Z-STACK in it with CC-DEBUGGER.

please help me to know what are the commands or procedure for interfacing it with host microcontroller on serial or spi.

over 1 year ago

0 YiKai Chen over 1 year ago

Guru 735455 points

Try to refer to https://radiocrafts.com/uploads/CC2530ZNP%20Interface%20Specification.pdf and e2e.ti.com/.../Z_2D00_Stack-Monitor-and-Test-API.pdf

0 Ryan Brown1 over 1 year ago

TI__Guru**** 202776 points

Hello sanjay,

You will need to access the UART peripheral RX/TX pins used to communicate with a host, which are further detailed in the guides YK provided. You can begin evaluation by establishing a connection to the ZNP using Z-Tool. There are similar E2E conversations which you can search for, starting with the "Similar topics" on the right side of this page.

Regards,
Ryan

Zigbee & Thread

Zigbee & Thread forum

CC2530: CC2530 interface with Host microcontroller