TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Zigbee & Thread

Zigbee & Thread

Zigbee & Thread forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Zigbee® & Thread support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search Zigbee® or Thread IC content or ask technical support questions on everything from self-healing mesh networks to OpenThread, building automation, and IoT applications. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] SENSOR-CONTROLLER-STUDIO: UART or I2C Communication Peripheral Expansion

    Ryan Brown1
    Ryan Brown1
    Part Number: SENSOR-CONTROLLER-STUDIO Sensor Controller Studio is used to write, test and debug code for the CC26xx/CC13xx Sensor Controller, enabling ultra-low power application design. The tool generates an interface driver consisting of C source…
    • over 2 years ago
    • Zigbee & Thread
    • Zigbee & Thread forum
  • [FAQ] CC2652R7: Matter -- Getting Started Guide

    Toby
    Toby
    Part Number: CC2652R7 Matter, formerly known as Project Connected Home over IP (CHIP), is a royalty-free connectivity standard developed within the Connectivity Standards Alliance , formerly the Zigbee Alliance. Matter runs on Thread and Wi-Fi® network…
    • over 4 years ago
    • Zigbee & Thread
    • Zigbee & Thread forum
  • [FAQ] CC2630: Device Not Recommended for Zigbee Project Development

    Ryan Brown1
    Ryan Brown1
    Part Number: CC2630 Other Parts Discussed in Thread: CC2650 , Z-STACK-ARCHIVE , , SIMPLELINK-CC13X2-26X2-SDK , Z-STACK , LAUNCHXL-CC26X2R1 , LAUNCHXL-CC1352R1 , LPSTK-CC1352R , LP-CC2652RB There exists a Z-STACK-ARCHIVE solution for the CC2630 / CC2650…
    • over 6 years ago
    • Zigbee & Thread
    • Zigbee & Thread forum
  • [FAQ] CC2538: Z-Stack 3.0.2 Known Issues and Fixes

    Ryan Brown1
    Ryan Brown1
    Part Number: CC2538 Other Parts Discussed in Thread: CC2531 , CC2530 , Z-STACK , , CC2592 This page contains known issues on the published Zigbee Software releases from TI. TI has a software release candidates and all fixes may not be available to developers…
    • over 6 years ago
    • Zigbee & Thread
    • Zigbee & Thread forum
  • [FAQ] CC2652R: SimpleLink™ CC13x2 / CC26x2 SDK Zigbee Certification

    Ryan Brown1
    Ryan Brown1
    Part Number: CC2652R Other Parts Discussed in Thread: Z-STACK , SIMPLELINK-CC13X2-26X2-SDK , CC1312R , CC1352R , , CC2642R Hello All, Z-Stack Core v1.0.0.0, part of Z-Stack 3.3.1 as included in the SimpleLink™ CC13x2 / CC26x2 SDK v3.10, has been certified…
    • over 7 years ago
    • Zigbee & Thread
    • Zigbee & Thread forum
  • [FAQ] Zigbee Packet Sniffing Solutions

    JasonB
    JasonB
    Other Parts Discussed in Thread: CC2531EMK Hi everyone, Packet sniffing is an essential part in understanding what is happening in your Zigbee network. As such, there are various Zigbee packet sniffing solutions that are currently available to you.…
    • over 8 years ago
    • Zigbee & Thread
    • Zigbee & Thread forum
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    CC2652P: why ZC send a Leave request to ZED automatically? 0 Locked

    659 views
    5 replies
    Latest over 1 year ago
    by Ryan Brown1
  • Answered

    CC2340R5: The end-device does not enter the low-power mode 0 Locked

    1007 views
    12 replies
    Latest over 1 year ago
    by Ryan Brown1
  • Suggested Answer

    CC2530: How can increase the signal strength? 0 Locked

    447 views
    1 reply
    Latest over 1 year ago
    by Ryan Brown1
  • Answered

    CC2530: dstShortAddr parameter of MSA_McpsDataReq() on broadcast coordinate mode 0 Locked

    650 views
    8 replies
    Latest over 1 year ago
    by Edan Lee
  • Answered

    CC2340R5: How to use the otaServer tool to start an OTA upgrade? 0 Locked

    670 views
    4 replies
    Latest over 1 year ago
    by senjin
  • Not Answered

    CC2652P: The network creation failed after the coordinator was powered on for more than 10 minutes 0 Locked

    543 views
    3 replies
    Latest over 1 year ago
    by Ryan Brown1
  • Not Answered

    CC2652P: Low temperature test problem 0 Locked

    916 views
    6 replies
    Latest over 1 year ago
    by Ryan Brown1
  • Suggested Answer

    CC2340R5: How is 'timer_settime' function is a blocking function in "TI-POSIX" even though it shows the ability to be used inside ISR in implementation ? 0 Locked

    403 views
    1 reply
    Latest over 1 year ago
    by Ryan Brown1
  • Answered

    CC2530: How to restart the network scan without turning off 0 Locked

    627 views
    6 replies
    Latest over 1 year ago
    by Edan Lee
  • Not Answered

    CC2652R7: Z-Stack 8.30.00 bug fixes 0 Locked

    458 views
    2 replies
    Latest over 1 year ago
    by Toby
  • Answered

    CC2340R5: When transferring data at a high load, system halted occasionally 0 Locked

    1216 views
    12 replies
    Latest over 1 year ago
    by senjin
  • Suggested Answer

    CC2340R5: it't avaliable to set the network layer retries and mac layer retries? 0 Locked

    436 views
    5 replies
    Latest over 1 year ago
    by senjin
  • Not Answered

    CC2652R: Programming CC2652R/CC2662R CCFG Region using Uniflash 0 Locked

    579 views
    3 replies
    Latest over 1 year ago
    by Toby
  • Not Answered

    CC2652P: same callback functions for different endpoints 0 Locked

    298 views
    1 reply
    Latest over 1 year ago
    by Toby
  • Answered

    CC2340R5: What methods can be used to set the RSSI threshold? 0 Locked

    369 views
    2 replies
    Latest over 1 year ago
    by senjin
  • Answered

    CC2652R: DMM with BLE Peripheral + Ti15.4 Coordinator - how to send frames longer than 125 bytes 0 Locked

    347 views
    1 reply
    Latest over 1 year ago
    by Ryan Brown1
  • Suggested Answer

    CC2340R5: As a router device, the link status message does not show all the entry 0 Locked

    672 views
    3 replies
    Latest over 1 year ago
    by Ryan Brown1
  • Suggested Answer

    CC2652PSIP: Is there a way to run CC2652PSIP as a Thread NCP? 0 Locked

    404 views
    1 reply
    Latest over 1 year ago
    by Ryan Brown1
  • Answered

    CC2652R7: SDK 6.20.00.29 0 Locked

    530 views
    7 replies
    Latest over 1 year ago
    by Robert Malczyk
  • Answered

    LP-CC2652RB: Could Not find the source for the Zigbee_3_0_Linux_Gateway_1_0_0 0 Locked

    396 views
    2 replies
    Latest over 1 year ago
    by Sundareswar Palanichamy
<>