How do I choose whether to use up-down or up-and-down mode for the ePWM module?

Why do my software breakpoints keep disappearing? I have a breakpoint set in code which is loaded into Flash and then runs from RAM. The breakpoint is set in RAM region where the code runs. Sometimes this breakpoint halts the code, sometimes it does…

Part Number: TPS65912 How do I get a version of the TPS65912 family with the default voltages and sequences for my application?

Part Number: TPS65912 For the TPS65912x, is the PWRHOLD pin high impedance and, as a result, will it always need to be driven?

Part Number: TPS65912 Why is the Iq on VCC pin increase when in off mode? About 30 uA typically but, in off mode Iq increases to 90uA?

While debugging an if statement, why is the statement within the "if" always executed?

Part Number: TPS65070 Other Parts Discussed in Thread: TPS65072 , TPS650732 , TPS650731 , TPS65073 How should I connect/terminate un-used pins on the TPS65070? The TPS65070 shares a datasheet with the TPS65072, TPS65073, TPS650731, and TPS650732. Does…

Part Number: TPS68470 What do I do with the PMIC pins if I don't use the wLED boost converter?

Part Number: TPS65708 Where are the TPS6570x EVM schematic and layout files located?

Part Number: TPS65010 Tool/software: Linux What should be done if the very first I2C write to the TPS65010 does not ACK the address byte?