RTOS/EVMK2H: Nand Flash fusing

Which RTOS SDK version are you using?

We are currently supporting only SPI NOR based boot on the Keystone II device that you are using with the secondary bootloader.

there is a NAND flash writer support in the SDK but the secondary bootloader doesn`t support booting from NAND. For NAND boot, you can look at the examples here:
processors.wiki.ti.com/.../KeystoneII_Boot_Examples

YOu will need to integrate the code that wakes up the DSP from SBL into those examples.

Regards,
Rahul

Hi

Thanks for your reply

SDK version is pdk_k2hk_4_0_4 .

I have more question.

1. I found a boot example one git.ti.com/keystone2_boot_examples but they have no examples/k2h/nand/multiStage

2. How could I make .dat file from .out file?

3. The example for ARM I think, The example applies DSP booting directly?

I need your help.

Regards.

Shin.

Hello??

Shin,

The SDK on this device currently supports on DSP boot master. If you are looking for DSP boot master example, then we had one prototype created using SPI boot which you can use as reference:

2330.DSP_SPI_boot_example.zip

These devices have been designed to have ARM to be the system master with the DSPs for accelerating signal processing and high performance compute so DSP boot is not a typical boot scenario so the support for this is limited.

Regards,

Rahul

Hi

I'd like to NAND flash conneted EMIF interface on the EVMk2H, instead of SPI NOR Flash. 

Please Check These things.

Regard.

Shin.