Z-Stack_Linux_Gateway_1_0_1_installer.run Installation on beaglebone black

THIHA KYAW85

Intellectual 760 points

Other Parts Discussed in Thread: Z-STACK

Hi,

How can I install Z-Stack_Linux_Gateway_1_0_1_installer.run Installation on beaglebone black?

Do you have step by step installation guide?

Regards,

Thiha Kyaw

over 10 years ago

0 YiKai Chen over 10 years ago

Guru 735625 points

Z-Stack_Linux_Gateway_1_0_1_installer.run is a script to run on Ubuntu 32 bit environment.You can refer to and e2e.ti.com/.../362710

0 THIHA KYAW85 over 10 years ago in reply to YiKai Chen

Intellectual 760 points

Hi YK Chen,

Now I understand that I need to use a Linux computer to run Z-Stack_Linux_Gateway_1_0_1_installer.run.

Regards,

Thiha Kyaw

0 THIHA KYAW85 over 10 years ago in reply to THIHA KYAW85

Intellectual 760 points

Hi YK Chen,

How can I config gateway_config.tlg for SampleSwitch, SampleTemperatureSensor?

Do you have any examples?

Please advise.

Thanks.

Regards,
Thiha Kyaw

0 YiKai Chen over 10 years ago in reply to THIHA KYAW85

Guru 735625 points

As I remember, SampleTemperatureSensor and SampleSwitch can join Linux Home GW directly after you enable permit joint on Linux Home Gateway.

0 THIHA KYAW85 over 10 years ago in reply to YiKai Chen

Intellectual 760 points

Hi YK Yhen,

It can join but I didn't see any ED under Device lists on console view. How can I see it?

Please advise.

Regards,
Thiha Kyaw

0 YiKai Chen over 10 years ago in reply to THIHA KYAW85

Guru 735625 points

If a device joins correctly to Z-stack Linux Home GW, it should show on device list. I suggest you to use Ubiqua Packet Analyzer to check if device joins correctly.

Zigbee & Thread

Zigbee & Thread forum

Z-Stack_Linux_Gateway_1_0_1_installer.run Installation on beaglebone black