MSP432P401R: BoostXL-Sensors

Carmen Chan

Part Number: MSP432P401R

I am using the MSP432P401R board along with the Sensor BoosterPack. I downloaded the GUI_ET and configured it correctly, however, it just stucks in waiting data. Do you have any suggestion what it might be?

I am using the black board version of MSP432.

Thanks.

Carmen

over 7 years ago

0 Cameron LaFollette over 7 years ago

TI__Genius 14875 points

Carmen,
Did you flash the MSP432 with the FW on the GUI?

I ran into a situation once where I needed to reset the MSP to work with the GUI.

0 Carmen Chan over 7 years ago in reply to Cameron LaFollette

Intellectual 325 points

Hello Cameron,

Thanks for your answer.

Yes, I did reset the MSP and uploaded the firmware with the GUI. I did a further research and I found the exact problem on this thread. I tried the boosterpack with two Rev1 boards (black) and none of them worked. Do you know if that boosterpack is compatible with Rev1(the webpage only said that it was compatible with the MSP432P401R but did not specify the rev)? If not, if there is a workaround to make it work with?

Thanks.

Carmen

0 DavidL over 6 years ago in reply to Carmen Chan

TI__Mastermind 25045 points

Hi Carmen,

We've deprecated support for MSP432Ware and moved all of our existing demos and code examples to use the new SimpleLink MSP432 SDK.

Having said that, the SimpleLink MSP432 SDK only supports Revision C silicon and above (RED Launch Pad).

Please get in touch with us offline and we can point you in the right direction (you can click on my profile and send me a private message that way).

Thanks,

David

0 Carmen Chan over 6 years ago in reply to DavidL

Intellectual 325 points

Thanks, I just sent it.

Carmen

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

MSP432P401R: BoostXL-Sensors