FAQ: Logic and Voltage Translation > Quality and Manufacturing >> Current FAQ TI's General Quality Guideline (page 7) describes our official policy on obsoleting a device. This policy is summarized below. TI's Product withdrawal/discontinuance process…

Part Number: BQ24610 Other Parts Discussed in Thread: BQ24650 , BQ24617 What are some key considerations when designing a schematic using BQ24610 or BQ24650, and what can I do if I want to simplify external component count by disabling some features…

Part Number: ISO224 Other Parts Discussed in Thread: , TLV6001 , OPA277 This might be a silly question, but is there any problem that might arise when tying the negative output of ISO224 to the low-side ground, GND2? My original plan was to do this…

Part Number: TPS63001 Other Parts Discussed in Thread: TPS63802 , TPS63000 Hi all, Currently we are using TPS63001 fixed 3.3V output DC-DC Converter. As per the TPS63001 DC-DC converter datasheet, module taking Quiescent current (Iq) is less than…

Q: After a "run", why did the CLA begin executing another task instead of stopping at MSTOP?

Q: Why does my Code Composer Studio GEL file enable the CLA clock on reset?

Q: Can I start a task from the debug (Code Composer Studio) window?

Q: CLA: If two masters (ex: C28x and CLA) can access the same device resource, which has priority?

Q: Can the CLA interrupt the C28x CPU? When and how can the CLA send an interrupt to the C28x?

Q: If the CLA takes an ADC interrupt, can the CLA then clear the ADC interrupt flag? If not, then how can I clear the flag?