Hi,
Here is the pspice file (zip) shown as *.mod (change the extension to *.cir or *.txt to use with your simulation) on the LMH6552 Product Folder (under "Tools and Software"):
Regards,
Hooman
Hi John,
It should be possible to synchronize the LM98722 AFEs as you are intending. You will need to make sure that the SH_R input meets setup and hold timing with the applied INCLK of each device. This will be easier to do if the INCLK is at pixel…
Hi Christian,
The latency through the device from INCLK to CLKOUT output will vary somewhat from part to part due to process variability, random mismatch, etc. For this reason you must use the CLKOUT output from each IC to capture the DOUTx data from…
Hello Frank,
The operating conditions you are asking about is what page 4 specifies (3.3V to 50V) and which is reiterated in the Operating Ratings table on page 5. The absolute maximum ratings are voltage levels that if you exceed you have the chance…
Hi Shinichi,
From talking to the designer, the answer I got was "the trailing edge is not going to occur at an accurate point, but the leading edge will be". Since he is no longer in my group, unfortunately I cannot push him for more detail.
I hope…
Hi,
That LMH6518 circuitry (Figure 69) comes from the Reference book listed in the datasheet:
"Wideband amplifiers by Peter Staric and Erik Margan, published by Springer in 2006. (Section 5.2)."
Maybe you can do a deeper dive by getting the book…
Hi Jared,
Please go ahead and forward all your schematics to that same TI email I provided and I'll forward it (internally only) as needed.
Regards,
Hooman
Hello Mark,
Unfortunately those parasitic capacitance values you asked for are not available, and I hate to just guess at some numbers.
I'm assuming that you need these values to predict the device behavior under conditions not covered in the datasheet…
Hello,
I am not entirely sure I understand the distinction you draw between the Power dissipation and Heat dissipation. I have always used these interchangeably as I believe any power dissipation will be in the form of heat that needs to escape the…
