Part Number: CAPTIVATE-FR2676 Other Parts Discussed in Thread: CAPTIVATE-METAL , CCSTUDIO Hello there,
I have a question in the following environment.
environment ・Application: CapTIvate Design ・Board used - CPU board: CAPTIVATE-FR2676 - Metal electrode…
Part Number: CAPTIVATE-EMC On the page below it seems to indicate that design files are available, but it may just be referring to software.
Does anyone know if Captivate-EMC PCB design files are available ?
Since this is a design focused on passing…
Hello Dennis Lehman,
The customer plans to enable the CapTIvate EMC feature and arrange the PCBs side by side.
Are there any settings or configurations in CapTIvate, other than the CapTIvate EMC feature, that could help mitigate this type of board…
Part Number: CAPTIVATE-BSWP Other Parts Discussed in Thread: CAPTIVATE-METAL , CAPTIVATE-EMC Hi
Please can you provide the CE/EU Declaration of Conformity for CAPTIVATE-BSWP?
The product shows it bears the CE mark however the declaration is not available…
Part Number: MSP430FR2676 Other Parts Discussed in Thread: MSP430FR2632 I was browsing around TI's website and I happened upon Captivate EMC.
https://www.ti.com/lit/wp/slay045b/slay045b.pdf
https://www.ti.com/tool/CAPTIVATE-EMC
At first, I thought…
Part Number: MSP430FR2675 Tool/software: Hello,
in my applicatation are unfortunately voltage breakdowns in the supply voltage of the MSP430FR2675. So, when this voltage breakdowns occur, it leads to a touch detect of the CapTIvate system. I know the…
Hi Kento,
If you asking can you place decoupling cap and TVS diode on a Captivate capacitive touch pin, no.
A typical decoupling cap is 0.1uF and exceeds the maximum 300pF limit. The TVS would add additional capacitance.
See the Captivate tech guide…
Hi Vaidas,
I did some test in my side and also consult CapTIvate expert then the calibration will need around 1 sec without EMC enable.
If enable EMC function, will take about 2~3 sec.
Thanks!
Best Regards
Johnson
Hello Hari,
CapTIvate can actually automatically sample at up to 4 different frequencies. See function calls here: https://software-dl.ti.com/msp430/msp430_public_sw/mcu/msp430/CapTIvate_Design_Center/latest/exports/docs/users_guide/html/CapTIvate_Technology_Guide_html…
Hello Sal, thank you for replying.
Regarding 1st question, I have attached code. I am driving a TPS switch through P2.7 (labelled as LED in the code). LED on P1.0 is not activated. I have also added a delay to keep TPS on for a little while.
void…
