Part Number: DRV8305-Q1 Other Parts Discussed in Thread: DRV8305 Tool/software: Hi Expert,
Have a nice day! I have question need your professional support:
For DRV8305-Q1, I don’t fully understand about the description of WAKE Pin.
What does …
Part Number: DRV8305-Q1 Tool/software: Dear Team，
DRV8305-Q1 has malfunctioned, and the DRV8305-Q1 fault code is read through SPI, as shown in the following picture.
Please help confirm the fault code of the DRV8305-Q1 driver chip register…
Part Number: DRV8305-Q1 Other Parts Discussed in Thread: DRV8305 Tool/software: hi expert
Is there any relevant design data and introduction for PIN38 VCPH, which is used to drive mos? Are there any separate precautions？
Part Number: DRV8305-Q1 Other Parts Discussed in Thread: DRV8305 Tool/software: Hello,
I have had this issue once before:
https://e2e.ti.com/support/motor-drivers-group/motor-drivers/f/motor-drivers-forum/1135604/drv8305-q1-high-current-after-setting…
Part Number: DRV8305-Q1
Tool/software:
The DRV8305-Q1 has a built-in 3-channel CSA (current sense amplifier).
Please tell me the temperature change rate variation (design value or actual value) among the 3 channels of the same IC for the following…
Part Number: DRV8305-Q1 Tool/software: Dear team,
Would I know temperature dependence of G_csa?
I could see the typical value of G_csa and G_err in 2 temperature range in datasheet. Can we get the graph that shows G_csa vs. temperature? is it positive…
Part Number: DRV8305-Q1 Other Parts Discussed in Thread: DRV8305 Tool/software: Hi TI Team, I have a basic question regarding the charge pump operation in the DRV8305-Q1 gate driver IC. In my application, the PVDD input voltage to the driver comes directly…
Part Number: DRV8305-Q1 Tool/software: Hello Experts, Let me confirm about CLR_FLTS. CLR_FLTS bit will be cleared automatically if customer set CLR_FLTS bit "1" even if fault register does not set(it means device has not been got any fault conditions…
Part Number: DRV8305-Q1 Tool/software: Dear TI experts,
My customer wants to calculate the output of current shunt amplifier based on the equation in the datasheet. (page 25)
My customer set the variants as below ;
V_vref = 5V (same as VREF) …
