Part Number: DS50PCI401 Hello TI team
I would like to know if this IC can be used for SLVS-MI signal lines.
According to the data sheet, it can be received the differential signal if the peak to peak is 0.1V or higher. Is this correct?
And is it possible…
Part Number: DS50PCI401 Other Parts Discussed in Thread: DS160PR410 Hi
The picture below is my block diagram. I am designing a PCIe add-on card with FR4 4-layer PCB.
The entire system has 0.22uF capacitors on the CPU TX side, and the root port can support…
Part Number: DS50PCI401 Other Parts Discussed in Thread: DS80PCI402 , SN65LVPE501
Hi
Working temperature needs -40~85 degrees GEN2 product Are there any other suggestions besides DS80PCI402
Preferably only GEN2
Part Number: DS50PCI401 Hi Team,
Please allow me to ask you the PCB design of the high speed line.
In the data sheet, it states input/output differential impedance is 100 ohm and is recommending to use controlled diffrential impedance of 100 ohm (TYP…
Part Number: DS50PCI402 Other Parts Discussed in Thread: DS50PCI401 , Hi team.
Thank you for your usual support.
I am suffering from device selection.
I think [DS50PCI401] and [DS50PCI402] seem to have the same characteristics.
Whis is your recommend …
Hi Jeroen,
For PCIe applications, we typically uses parts such as DS50PCI401/402. These parts do RX detection - mainly used in PCIe applications - and operate in linear mode with a wide bandwidth. Beacon signal is a low frequency signal and is generated…
Other Parts Discussed in Thread: DS50PCI401 , DS50PCI402 Hi Team,
Customer needs redriver proposal for RGMII and SGMII, any suggestion parts?
Thanks!
Both case = 1G speed. (DP83867)
PCB length RGMII : 8000 mils （carrier allow 6000mils only）
PCB length …
Part Number: DS50PCI401 Hello,
Our customer use the DS50PCI401, have Link-up issue.
The customer configure the equalization level during PCIe Link training sequence.
But I think the customer should configure the equalization level before Link training…
For PCIe Gen1, please consider the followings: DS50PCI401/402, SN65LVPE501/504/512 or SN65LVPE802.
They can use one part to connect to two device.
Regards ,,Nasser
![[FAE] Andrew Wang](https://e2e.ti.com:443/cfs-filesystemfile/__key/communityserver-components-imagefileviewer/communityserver-components-avatars-00-00-07-45-83/4TN3ECJKFL7N.jpg_2D00_24x24x2.jpg?_=637507717131076795)