Part Number: DS64BR111 Tool/software: Hi Ti staff.
I would like to know the min value of the differential input threshold voltage of this IC. In our system, the min differential output is 160mVp-p.
The default min value of this IC is 190mVp-p. Please…
Hi Nasser,
Another question, we found out that DS64BR111's VOD had over SLVS-EC Rx spec. Can you help to check on this? Or we have other suggestion?
Thanks,
Len
Part Number: DS64BR111 Hey team,
Do we have any equivalent reference circuit of how the CML input / outputs look like so simulations can be done? I know we have the IBIS Model online, but no pspice model.
Thanks,
Cam
Part Number: DS64BR111 Hey team,
Wanted to quickly clarify the 5kV ESD Protection we have on the device - I assume it applies to all pins including the CML inputs/outputs? I'm not overly familiar with how JESD22-A114F works.
Thanks,
Cam
Part Number: DS64BR111 Hi,
I am using two SATA III ports for two different SSD
SATA III signal is routed via FR4
one SATA III port routed for the length of 5 inches and connected to SSD via redriver second SATA III port routed for the length of 5 inches…
Part Number: DS64BR111 Team,
The pin descriptions on page 3 has 2 sections, one for ENSMB=1 (SMBUS mode) and one for ENSMB=0 (pin mode). I am using it in ENSMB=1. Pin 6 and 16 are only defined in the ENSMB=0 part of the table. What are these pins on the…
Part Number: DS64BR111 Hi TI,
We are using the 64BR111.
I had a quick question I wanted to be sure about.
How do I handle unused SERDES inputs?
I see 50 ohm pullups in some of the figures but the datasheet on pg. 3 says"
"An on-chip 50Ω termination…
Part Number: DS64BR111 Other Parts Discussed in Thread: DS100BR111 Hello,
I'm working on SI simulation for backplane analysis using hyperlynx. DS64BR111 is used and transmitter and receiver across backplane channel. I have below queries for DS64BR111…
Part Number: DS64BR111 Hello,
We have approximately 20 inches of copper length on PCB (FR4) between outputs of ds64br111 to receiver (with 2 contacts on the way). The receiver has equalization on input (set to equalize 18 inch over FR4).
Can you suggest…
Part Number: DS64BR111 Other Parts Discussed in Thread: DS100BR111 , DS100BR210 Hi Team,
I am looking for a driver/buffer IC that can drive the input of SFP(4.25Gbps) transceiver. ・FPGA outputs CML signal on the board and inputs it to SFP. ・The specifications…
