Part Number: DS90LV004 Tool/software: Hello, I need to pull the failsafe biasing state to 0 when there is no signal.
The datasheet says to place pull-up / down resistors between 5kohms and 15kohms in order to have a differential voltage of at least…
Part Number: DS90LV004
I’m responsible for displays interfaces. And there I have some questions regarding LVDS redriver TI DS90LV004TVS/NOPB
1) On TI’s web is written that Eval kit is available, but I didn’t found it. Especially I’m interested for…
Part Number: DS90LV804 Tool/software: Hi,
Can you please suggest that if I can connect the NC pins 23 and 24 of DS90LV804 to GND?
Also, can you please provide the reference layout for this IC.
Many Thanks
Best Regards
Mohsin
Part Number: DS90LV004 Hi TI Staff,
I am using this part DS90LV004 in my design. However, there is no spice model from TI website. I would appreciate if the spice model can be generated. This part is important to handle the clock and data with low noise…
Part Number: DS90LV004 Hi,
Is open input failsafe circuitry recommended in addition to a DS90LV004 when in a situation where Vcc = 0V and the inputs are actively being driven by another device, likely an FPGA in this case?
Thanks, Peter
Part Number: DS90LV004 Other Parts Discussed in Thread: SN65LVDS109 hii
As it is given that output will be in high impedance state in power down mode , but there is an internal 100 ohm resistance terminated across outputs , so the impedance looking…
Hello,
Just to confirm the requirements, you need buffers that will take sub-LVDS input and produce sub-LVDS output, right? If that's the case, we don't have any such buffers, unfortunately. Using LVDS RX/TX won't work either, since we don't have a…
Part Number: DS90LV004 Hi,
Is the DS90LV004 able to handle a +/-1.5% spread spectrum clock generation (SSCG) source?
For this specific use case, the customer LVDS clock channel is 37MHz and the LVDS data channels are at 260MHz.
Thanks! Re…
Hi Teck,
1. You can use any source that can output an LVDS signal
2. LVDS is purely electrical so there are no test sequence packets
3. You can test the signal quality with an eye diagram. For most devices you'll typically want to see a minimum…
