Part Number: DS90UB941AS-Q1 Hi team,
The DS90UB941AS-Q1 has a VDDIO supply of 1.8V. However, the IIC pull-up is 3.3V. Is this acceptable?
Thanks
Xiaoxiang
Part Number: DS90UB941AS-Q1 Tier1 Tianma/ OEM VW
Hi Team,
config: SOC-941-948-slave
My customer wan t to access the 948 register from SOC, I would like to know what register i need to configure to enable the I2C pass through for this operation:
Should…
Part Number: DS90UB941AS-Q1 Hello Team,
I got question from my customer if 941AS support interrupt in case error case.
I understand this is for passing INTB_IN at DES to INTB at SER. but I also found bit6 that indicate LOCK for INTB.
I think this is…
Part Number: DS90UB941AS-Q1 Other Parts Discussed in Thread: ALP , USB2ANY Hello TI team,
Why did 941 register reset itself?
We encounter occasional flickering/black screen phenomenon, and the software detects that the 924_LOCK is link down;
Verify…
Part Number: DS90UB941AS-Q1 Dear Team,
I am using DS90UB941AS in my design.
I know this will convert DSI to FPD.
I need to convert this FPD to RGB.
Can you suggest any IC for the same(FPD to RGB)
Regards
HARI
Part Number: DS90UB941AS-Q1 Hi experts,
we have a issue for i2c communication NAK on local bus, after reproduce this issue, we found that remote i2c bus stuck low for long time. please help us to find the root cause.
MCU( 0x6B ) is setup as ( 0x6D…
Part Number: DS90UB941AS-Q1 Other Parts Discussed in Thread: ALP Hi,
We debug the 941/928 display, Soc -> 941 -> FPDLINK III -> 928 -> LVDS Screen
The 941 can read and write normally, the 928 can't. But The 948 instead of 928 is ok. …
Part Number: DS90UB941AS-Q1 The display screen is 1920 * 720, 60fps
1920*720*60*1.15*35bit=3.34G
Why does the eye chart display a frequency of 1.698G after stringing? Is the FPD LINK signal DDR?