Part Number: LMH0366 Other Parts Discussed in Thread: LMH0395 , Hello
I am not sure if I have chosen the right forum. Thanks if someone suggests me a more suitable one.
IC's: LMH0366 and LMH0395
What is the behavior of the ICs at temperatures of…
Part Number: LMH0366 Other Parts Discussed in Thread: LMH0397 , LMH0318 Hi team,
I am new for this device, so could you please answer my questions?
1. My customer would like to make the output impedance 75 ohm with SDI output. Is it possible?
2…
Part Number: LMH1226 Other Parts Discussed in Thread: LMH0366 , Hi team,
My customer has following questions and request.
(1) Can LMH0366 be replaced with LMH1226?
LMH1226 needs to support SD-SDI/HD-SDI(1.485Gbps) and 3G-SDI(2.97Gb/s).
(2) Can…
Hi, TI. I have a question of Signal detect function, If the input signal was changed from signal A to Signal B( A and B are same rate and same phase but different movi, I guess the device will not into unlock state ), Does the "Signal detect function…
Other Parts Discussed in Thread: LMH0366 Hello,
A customer of mine is experiencing increased output jitter when using the multiple LMH0366 on a board. The problem occurs when 3G video is driven through the part. When switching between bypass and reclock…
Hi Renzo,
I need your help to better understand the problem and solution. It is is not clear to me why weak pull-up on SPI would cause lose of lock. Can you send your schematic to me through email, I would like to have my engineer to review.
Can you…
Hi Riaan,
1). The settings you have outlined are correct.
2). These settings increase the loop bandwidth and thus enables the device to track injected noise. With these settings, the output jitter could increase(as you noted).
3). This should…
Other Parts Discussed in Thread: LMH0366 Hi ,
Can a single cmos oscillator be used as the 27 MHz reference for multiple reclockers by connecting the XTAL_OUT output of one reclocker to the XTAL_IN input of the next, propagating the 27 MHz reference…
