The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: MAX3223E Tool/software: The test found that there is signal input in Pin12/13, but no signal output in Pin17/18. After replacing the chip, the recovery is abnormal. Please kindly check the cause, thank you
Part Number: MAX3223E Tool/software: Dears:
when customer use below circuit, they found MAX3223E can't use auto power down function, they need pull up forceon pin, then MAX3223E can work. Could you please help check if below circuit is ok ? Thanks.…
Part Number: MAX3223E Other Parts Discussed in Thread: TVS1401 Hi,
My customer want to have RS232 transceiver with supporting Vrx > 36V, currently MAX13223E could support this requirement.
May I know whether TI have similar part?
According to TI cross…
Part Number: MAX3223E Other Parts Discussed in Thread: TRSF3221E , TRS3221E , MAX3221E Hi team,
If the use-case is that 2nd channel (DIN2・ DOUT2 ・ RIN2 ・ ROUT2 ) was not used, how can customer to set pins? Open or pull-up to Vcc or pull-down to GND?
Regards, …
Part Number: MAX3223E Other Parts Discussed in Thread: MAX3223 , Hello team -
TI sent EOL notice for the MAX3223 and recommended the MAX3223E as a pin to pin replacement. Can you tell us what the differences are between MAX3223IPW and MAX3223EIPW. We are…
Part Number: MAX3223 I connect 2 MAX3223 transceivers together, I am seeing a sawtooth/rippling waveform on the positive pulse on pin 17 (Tx) output. There is a 6" cable between the RS-232 transceivers. One of the transceivers appear much worst then the…
Part Number: MAX3223E Hi Team,
Good day. I am posting this inquiry on behalf of the customer.
"I have been experiencing a very high failure rate using this part in a 3.3 volt system. The signature of the failure is an extremely high current draw…
Part Number: MAX3223-EP Team,
My customer had the following request:
I was asked to find out if a socket exists for TI part MAX3223MDBREP that can be installed onto a CCA and used for pre-screening purposes. Do you know if such a socket exists?
Let…
Part Number: CC2538-CC2592EMK Other Parts Discussed in Thread: CC2538 , MAX3223 Tool/software: hi team ,
am designing a custom board based on the CC2538 microcontroller, and I would like to share the UART communication configuration . The setup involves…
Part Number: SN65HVD72 Other Parts Discussed in Thread: MAX3223 Tool/software: In general, it seems these RS485-to-UART converters have a standby/shutdown mode with low current BUT only when the device is fully disabled. This is great for my battery powered…
