Part Number: MSP430F5324 Other Parts Discussed in Thread: MSP-GANG Hi experts,
I tried to calculate the checksum as described below.
However, the result is not equal to CS value in GANG GUI.
Is the method of calculating the checksum between this manual…
Part Number: MSP430F5324 Other Parts Discussed in Thread: MSP-GANG Hi experts,
I have a question regarding the MSP-GANG-SOFTWARE Verify feature. When "Go" of MSP-GANG-SOFTWARE is pressed, "Erase > Blank Check > Program > Verify > blow fuse" is…
Part Number: MSP430F5324 Hi Team,
What's the input impedance of MSP430F5324's internal ADC(referred to gnd)? I only find input capacitance in datasheet.
Thank you!
Marc
Part Number: MSP430F5324 Hi Champs,
a customer reported an issue with the GPIO interrupts. The same issue was already reported by Leo Hendrawan in 2014 and it might be linked to the specific configuration why this has not been seen more often:
Port1 pins…
Part Number: MSP430F5324 Tool/software: Code Composer Studio Hi All,
I am working on MSP430f5324 controller, I want to know the lowest and highest range of baudrate to communicate with modbus.
Thanks,
Sandhya
Part Number: MSP430F5324 Other Parts Discussed in Thread: MSP430F5326 , MSP430F5328 I have qualified the MSP430F5324 (6k RAM, 64k Flash) device in my design. I would like to add the larger MSP430F5326 (8k RAM, 96k Flash) and MSP430F5328 (10k RAM, 128k Flash…
Part Number: MSP430F5324 Other Parts Discussed in Thread: MSP-GANG Hi:
I'm involved in mass production of a product where a board with a MSP430F5324 is used, there are some failures, and I tried to install an elprotronic flashpro430, in test equipment…
Part Number: MSP430F5324 Other Parts Discussed in Thread: CC-DEBUGGER , MSP-FET , MSP-GANG The problem involves programming a TI MSP430F5324 MCU using a TI MSP MCU Programmer and Debugger ( http://www.ti.com/tool/MSP-FET ). This problem is occuring on prototypes…
Part Number: LP-MSPM0G3507 Other Parts Discussed in Thread: SYSCONFIG , MSP430F5324 , MSPM0G3507 Hi Sir
A Timer has only one counting register, but if it supports two channels, can I set TimG6 CCR0 as the comparison output and CCR1 as the capture input…