Part Number: SCANSTA112 Tool/software: Hi Team
below is question from y customer side and my current response could you help me check it?
Would both multi-master and signal reflection can be acceptable in this topology? Brian>> I think multi-master…
Part Number: SCANSTA112 Tool/software: Hi Team
can you share below information to us
Multidrop JTAG layout guide on backplane side
How to solve two master as below picture: solution & layout recommend.
Because they have two master JTAG debugger…
Part Number: SCANSTA112 Tool/software: Hi,
SCANSTA112 IC appears as NRFND in the supplier company Digikey.
But, It as Active on your website. Can we get information on this matter?
How long is support provided for this IC? What date is expected for it…
Part Number: SCANSTA112 Other Parts Discussed in Thread: TMUX1574 , Tool/software: Hi expert,
Customer is looking for JTAG mux for below application. Is SCANSTA112 good for it? How about using 1:2 TMUX1574 *2?
If both can work, could you please advise what…
Part Number: SCANSTA112 Other Parts Discussed in Thread: SN74CB3Q3251 Hello Team, We are designing a product that follows backplane architecture. Each daughter PCBs (that are connected to the back plane) will be connected to some DUTs. We need to update…
Part Number: SCANSTA112 Other Parts Discussed in Thread: TMUX1309 , SN74LV4051A , TMUX1308 , TMUX1574 Hello,
We are planning to use SCANSTA112 IC as a switch/multiplexer for parallel programming of multiple boards through any debugger.
Can this IC be used…
Part Number: SCANSTA112 Other Parts Discussed in Thread: SCANSTA111 , Hi team,
My customer would like to use this device and they are wondering if there are known erratas for the SCANSTA111 & 112.
Thanks in advance for your feedback,
Regards,
Pol.
Part Number: SCANSTA112 I have a SCANSTA112 device between a FlashPro Lite programmer and a ProASIC Plus device I am trying to program. My programming plan is to first place the SCANSTA112 into full transparent mode. Then I should be able to connect up…
Part Number: SCANSTA112 I need to configure this TI JTAG Multiplexer (SCANSTA112) in Scan bridge Mode (using the JTAG port). My only JTAG tools are from the Intel Quartus Prime and Micro Semi Flash Pro tools. These tools are FPGA specific and I don't…
